laboratory tablet pressThe structure is simple, the actual operation is convenient, the size is small, the weight is light, is conducive to handling and transportation. When there is no switching power supply, it can be used to press candy by hand. The following is the correct operation method of the laboratory tablet press.

The laboratory tablet press can press granules and small granules into annular or special-shaped flakes below 12mm, with a production capacity of 9000-15000 tablets/hour, which can be adjusted at will. If you use it, you need to know that the design of the equipment is simple, compact, light in weight, and simple in actual operation. It is suitable for the pharmaceutical industry, food, chemical plants, electronic equipment and other fields. Equipped with overpressure protection device, automatic shutdown when working pressure is loaded. The equipment is equipped with safety protection equipment such as electromagnetic induction braking system motor, which can be adjusted during operation. During the operation of the laboratory tablet press, it should be noted that all oil marks, oil inlet and friction surfaces must be lubricated before use, and idling, so that each friction surface is covered by slick oil to increase the service life of the equipment. Several water pressure tests are required for hand cranks before each shift and after each break. If there is no problem, turn on the electric tabletting sugar, the laboratory tablet press can extend the service life of the mold shell.

After the laboratory tablet press is cleaned, apply a layer of food-grade stainless steel grease (vehicle oil and vegetable oil are acceptable), put it into a professional maintenance box or stamping mold storage box, and put it on the shelf. The specification, model and specifications should be marked and stored on a shelf. After all these are completed, the laboratory tablet press will select the raw materials to make granules before compressing the candy, so as to prevent the flaky loose tablets, fragments and tablet weight differences caused by the raw materials when compressing the candy. In addition to these, it is also necessary to master the correct choice of tablet type is a successful step in the stamping die of tablet candy. For example, chewable tablets have high strength requirements and are easy to be bitten, because most laboratory tablet presses use arc-shaped X-rays. Dents can be selected for those that must be coated. Since there is no adhesive and lubricant in the raw materials of Chinese medicine pills, it is stipulated that the working pressure should be large when tabletting candy, and the shape of the tablets should be shallow and concave. Flakes with high sugar content, especially the design of the device, are suitable for shallow concave or flat view. The middle die can be made of carbon steel or hard aluminum alloy. Deep concave plate stamping die is easy to damage, so try to avoid. When the laboratory tablet press installs the stamping die, if you directly touch the middle die, it is very likely that the stamping die will really be operated. You can put a piece of wood on the edge of the table, and then shake the rocker, especially after the end of daily use, you should clean up the residual powder and wipe the equipment clean. If it is not used for a long time, the stamping die must be removed and the friction surface of the equipment must be removed. The work surface should be cleaned, coated with anti-rust agent, and covered with anti-fouling clothing; the stamping die should be cleaned and soaked in oil for preservation.