automatic tablet pressIn the process of use, it is inevitable that there will be various failures. Don't worry after a malfunction. Carefully check the status of the machine, find out the cause of the failure, analyze the cause of the failure, and then find a solution. The following are the use methods of the tablet press and the precautions during use:

Before using the machine, please read the machine instructions carefully and then use it.

Preparations before the start of the fully automatic tablet press:

1. Check whether the circuit connection is correct.

2. Check whether the mobile part of the communication room is normal. If there is lubricating oil, oil it once before starting.

3. Check whether the mold device is tight, correct and stable, with or without missing edges, cracks, deformation and looseness.

4. Check whether the dust-proof board, hopper, feeder, semi-circular cover and other parts of the full-automatic tablet press are installed correctly.

5. Before starting the machine, the test piece wheel must be turned by hand to adjust the filling amount and pressure of each side respectively, so as to gradually reach the weight and hardness of the tablet and meet the requirements of the finished product.

6. Check whether the dry humidity of the particles meets the requirements of the finished product.

How to maintain the life of a fully automatic tablet press? Accurate maintenance of a small tablet press can not only extend its "service life", but also help you save some unnecessary expenses.

1. Regularly check the parts of the tablet press, 1-2 times a month, check whether the worm gear, worm, bearing, pressure wheel, crankshaft, upper and lower guide rails and other moving parts are flexible and worn, and find out the deficiencies in the application in time.

2. Take out the residual powder and clean up the residual powder in the name part of the machine every time you use the tablet press or resume working hours. If the machine is not used for a long time, the mold must be completely removed and wiped clean. Apply anti-rust oil to a smooth surface and cover with a cloth cover.

3. The maintenance of the mold should be placed in a covered iron box, so that the mold can be immersed in oil to keep it clean and avoid rust and scratches. To custom iron box packing one. Every specification. It can prevent installation errors during use and help control defects.

4. The application area of the automatic tablet press should be cleaned frequently, especially the production of tablets with the same source of medicine and food, which is not suitable for dust and flying dust. Accurately achieving the above four points can make the mini-tablet press efficient and safe to use, and at the same time extend the "service life" of the basic application, thereby saving energy and environmental protection, and increasing unnecessary expenses.