three-layer tablet pressPressing all kinds of granular raw materials into round tablets, suitable for laboratory trial production or small batch production of various tablets, sugar tablets, calcium tablets, etc. It is a small desktop electric (manual) continuous tableting machine. The machine is equipped with a die. The filling depth of the material and the thickness of the tableting can be adjusted.three-layer tablet pressIt can press the powder granular raw materials into tablets, has strong adaptability, easy to use, easy to maintain, and the thickness of the tablets can be adjusted. It can adapt to the requirements of the pharmaceutical industry to press various Chinese and Western medicine preparations and the requirements of other industries to press various similar products. It is welcomed by the majority of users in various industries. _Multifunctional Tablet Press_Catalyst Tablet Press_High Speed Tablet Press_Disinfectant Tablet Press_Tablet Press

three-layer tablet pressInstallation and wiring of:_multifunctional tablet press_catalyst tablet press_high-speed tablet press_disinfectant tablet press_tablet press

1,three-layer tablet pressInstalled on a solid wooden workbench (can also be installed on a cement table) and fixed with anchor screws. The height of the work surface to the ground is about600Millimeter or so (by hand, easy to operate). In order to facilitate disassembly and repair, the position piece corresponding to the lower punch core rod on the wooden workbench should also have a diameter of about35mm hole.

21. Connect the motor to the ground wire before connecting the motor power to ensure safety. Remove the V-belt, turn on the power supply of the motor, start the motor to observe whether the rotation direction of the motor is correct (the rotation direction of the motor shaft should be opposite to the arrow direction on the protective cover or hand wheel). If the rotation direction is wrong, connect separately and then install the V-belt.

three-layer tablet pressHandling and unloading of stamping dies and adjustment during tabletting:_multifunctional tablet press_catalyst tablet press_high-speed tablet press_disinfectant tablet press_tablet press

1Installation of upper punch: unscrew the lower punch fixing screw, turn the hand wheel to raise the lower punch core rod to the highest position, insert the lower punch rod into the hole of the lower punch core rod (pay attention to align the notch slope of the lower punch rod with the lower punch fixing screw and insert it to the bottom), and then tighten the lower punch fixing screw.

2Installation of underpunch: loosen the upper punch fastening nut, insert the upper punch core rod into the hole of the upper punch core rod to the end, use a wrench to clamp the hexagon at the lower part of the upper punch core rod, and tighten the upper punch fastening nut.

3Installation of the middle die: loosen the fixing screw of the middle die, place the middle die flat into the hole of the middle die platen, and at the same time make the down punch into the hole of the middle die, press to the bottom, and then tighten the fixing screw of the middle die. When placing the middle mold, pay attention to leveling the middle mold to avoid jamming and damaging the hole wall when placing it askew.

42. Rotate the hand wheel by hand to make the upper punch slowly descend into the middle die hole, and observe whether there is collision or friction. In case of collision or friction, loosen the fixing screw of the middle die platen, adjust the fixing position of the middle die platen, make the upper punch enter the middle die hole, and then tighten the fixing screw of the middle die platen. The installation is qualified until there is no collision or friction when the upper punch enters the middle die.

52. Adjustment of the piece: Turn the hand wheel to raise the lower punch to the high position, and observe whether the lower punch surface is flush with the plane of the middle die (or high or low will affect the piece). If not, loosen the butterfly screw, loosen the gear pressing plate to convey the upper adjusting gear, make the lower punch surface flush with the plane of the middle die, then still press the pressing plate up and tighten the butterfly screw.